3d-printing

5 articles tagged with “3d-printing”

articles

If you've ever loaded a default filament profile into OrcaSlicer and wondered why your benchy has stringing or your overhangs look rough, you're not

articles

When I upgraded from an Ender 3 Pro to an Anycubic Kobra S1, the firmware decision was the most impactful choice I made. Going with Rinkhals — a Klip

articles

When a print fails, it's tempting to change the first setting that comes to mind — increase retraction, lower the temperature, slow down the speed. B

articles

3D printing gives you the freedom to make almost anything — but what if the design itself could be generated by algorithms? That's the promise of **g

articles

I've been 3D printing on and off for a few years now, starting with an **Ender 3 Pro** and recently upgrading to an **Anycubic Kobra S1**. This artic